Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

■ Use the no version to set the system to retrieve bulk statistics periodically, the
default situation.
■ See bulkstats collector.
bulkstats interfaces description-format common
■ Use to set the encoding scheme of the ifDescr object that the bulk statistics
application reports to the conventional industry method.
■ This command provides compatibility with software that uses the industry
encoding scheme.
■ For more information, see “Configuring Encoding Method” on page 162.
■ Example
host1(config)#bulkstats interfaces description-format common
■ Use the no version to return to the proprietary method of encoding.
■ See bulkstats interfaces description-format common.
bulkstats interface-type
■ Use to configure the interface or subinterface type on which you want to collect
statistics.
■ You can provide an interface specifier (location) to identify a specific interface
on which you want to collect statistics.
■ If you define more than one collector, you must specify a unique collector index,
in the range 1–65535.
■ The supported interface types are:
■ atm—Collects statistics on ATM interfaces
■ atm1483—Collects statistics on ATM 1483 interfaces
■ ethernet—Collects statistics on Ethernet interfaces
■ frame-relay—Collects statistics on Frame Relay interfaces
■ frame-relay-sub—Collects statistics on Frame Relay subinterfaces
■ hdlc—Collects statistics on Cisco HDLC interfaces
■ ip—Collects statistics on IP interfaces
■ mplsMajor—Collects statistics on MPLS major interfaces
■ mplsMinor—Collects statistics on MPLS minor interfaces
■ mplsL2shim—Collects statistics on MPLS shim interfaces
■ ppp—Collects statistics on PPP
■ vlan—Collects statistics on VLAN subinterfaces
202 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English