Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

■ CollectorIndex—Index number of the collector to which the interface
type applies
■ State
■ active—Interface type is properly configured and currently active
■ notInSvc—Interface type has been decommissioned by a
management client
■ notReady—Interface type does not have enough configuration
information to go active
■ error—Configuration or operational error
■ Receiver Information:
■ Index—Index number of the receiver
■ RemoteFileName—Hostname, path, and filename of the remote FTP
server
■ State
■ active—Receiver is properly configured and currently active
■ notInSvc—Receiver has been decommissioned by a management
client
■ notReady—Receiver does not have enough configuration information
to go active
■ error—Configuration or operational error
■ Status
■ Success
■ Copy source does not exist or is unreachable
■ Copy failed
■ File in use
■ Virtual Router Groups:
■ Collector—Number that identifies the particular data collector, in the
range 1–65535
■ Virtual-Routers—Set of virtual router names (up to 64 names)
■ Example
host1#show bulkstats
AdminStatus: enabled
OperStatus: enabled
Interface Description Setting: industry-common
File Format: CR+LF
Current Time: TUE AUG 15 2002 15:54:20 UTC
Collecting Bulk Statistics ■ 207
Chapter 4: Configuring SNMP