Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

■ notReady—Collector does not have enough configuration information
to go active
■ error—Configuration or operational error
■ Index—Bulk statistics collector index number
■ Primary-Receiver—Index number of the primary receiver to which the
system transfers data, if defined
■ Second-Receiver—Index of the secondary receiver to which the system
transfers data
■ Last Transfer Failure—Last time that the collector attempted to retrieve
statistics and was unsuccessful
■ Interval Start Time—Start of current interval of bulk collections. The
collector began collecting bulk statistics at this time.
■ Interval Stop Time—End of current interval of bulk collections.
■ Schema Information:
■ Index—Index number of the schema
■ Subtree—Type of bulk statistics schema configured on the collector:
if-stack, if-stats, policy, QoS, or system
■ CollectorIndex—Bulk statistics collector index number
■ Create-Delete Time Stats—State of final statistics collection (enabled or
disabled)
■ Create-Delete Interface Type—Interface type associated with final
statistics collection (ATM 1483, IP, PPP)
■ State
■ active—Schema is properly configured and currently active
■ notInSvc—Schema has been decommissioned by a management
client
■ notReady—Schema does not have enough configuration information
to go active
■ error—Configuration or operational error
■ Subtree List—Types of statistics the schema is configured to receive
■ Interface Types:
■ Index—Index number of the interface type entry
■ Type—Interface type for which bulk statistics collection is configured
206 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide