■ Index—Bulk statistics collector index
■ CurrSize—Current size of the bulk statistics storage file in bytes
■ CreateErrs—Number of bulk statistics collector create errors
■ Last Transfer Failure—Last time that the collector attempted to retrieve
statistics and was unsuccessful
■ Interval Start Time—Start of current interval or bulk collections. The
collector began collecting bulk statistics at this time.
■ Interval Stop Time—End of current interval of bulk collections
■ Dynamic Interface Collector statistics:
■ Collector Index—Bulk statistics collector index
■ Slot#—Slot number from which the statistics were obtained
■ Received—Number of records for dynamic interfaces that were reported
by the specified interface
■ Transferred—Number of record for dynamic interface that were written
to the bulk statistics (.sts) file.
■ Dropped—Number of records for dynamic interfaces that were dropped
(that is, not written to the bulk statistics [.sts] file)
■ Example
host1#show bulkstats statistics
AdminStatus: enabled
OperStatus: enabled
HdwDetects: 4
HdwCollectorCreates: 8
CollectorCreateReqs: 2
CollectorStopReqs: 0
CollectorDeleteReqs: 0
CollectorStarts: 25
CollectorIncompleteCfgs: 3
CollectorStopFailures: 0
DriverErrors: 0
FileSizeFulls: 0
CollectorFileNearlyFullTraps: 0
CollectorFileFullTraps: 0
Intervals PrimaryXfers PrimaryFails SecondaryXfers SecondaryFails
--------- ------------ ------------ -------------- --------------
24 18 5 0 0
BulkStats Collector Statistics:
Index CurrSize CreateErrs Last Transfer Failure
----- -------- ---------- ----------------------------
1 331 0 MON JAN 24 2001 17:21:33 UTC
2 0 0
Index Interval Start Time Interval Stop Time
----- ---------------------------- -------------------------
Collecting Bulk Statistics ■ 213
Chapter 4: Configuring SNMP
To Next Page
Loading...