Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

1 MON JAN 24 2001 19:09:33 UTC MON JAN 24 2001 19:15:33 UTC
2 Not started N/A
Dynamic Interface Collector statistics:
CollectorIndex Slot# Received Transferred Dropped
-------------- ----- ---------- ----------- ----------
1 1 0 0 0
■ See show bulkstats statistics.
show bulkstats traps
■ Use to display information about the bulk statistics traps configured to collect
statistics.
■ Field descriptions
■ Trap Type
■ nearly-full—Trap will be posted to the SNMP entity on this system when
the threshold is reached
■ file-full—Trap will be posted to the SNMP entity on this system when
the trap reaches 100%
■ State—Configuration setting: enabled, disabled
■ Threshold—Nearly full trap will be posted to the SNMP entity on this system
when this percentage is reached
■ Traps Sent—Number of times this event was posted to the SNMP entity on
this system
■ Example
host1#show bulkstats traps
Trap Type State Threshold Traps Sent
----------- ------- ---------- ----------
file-full enabled N/A 0
nearly-full enabled 5 0
■ See show bulkstats traps.
show bulkstats virtual-routers
■ Use to display information about the bulk virtual router group configuration.
■ Field descriptions
■ Collector—Number that identifies the particular data collector, in the range
1–65535
■ Virtual-Routers—Set of virtual router names (up to 64 names)
■ Example
host1#show bulkstats virtual-routers
214 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide