■ Use the no version of this command with the subsystem name to remove a
subsystem from the exclude list. Use the no version of this command without a
subsystem name to remove all subsystems from the exclude list.
■ See exclude-subsystem.
show subsystems
■ Use to determine which subsystems are included in the current software release
on the system or in a specified software release file.
■ Specify either a local filename or a remote path and filename to view the
subsystems that are included in a software release file other than the current
software release on the system.
■ Field descriptions
■ Required—Number of bytes of data for the required portion of the release.
■ Included Subsystems—Number of bytes of data for the included subsystems
listed. All included subsystems in the release are listed.
■ Excluded Subsystems—Number of bytes of data for the excluded subsystems
listed. All excluded subsystems in the release are listed.
■ Use the command before you copy a release to verify which subsystems are
present in the release.
■ Example
host1#show subsystems file m:/x/images/x-y-z.rel
oc3
oc12p
oc12a
ge
fe8
coc12
oc12s
■ Use the command after copying a release to verify which subsystems are included
and excluded.
■ Example
host1#show subsystems file x8.rel
Required: 1423005 bytes
Included Subsystems: 27882192 bytes
oc12p
oc12a
ge
fe8
coc12
oc12s
Excluded Subsystems: 6840211 bytes
oc3
■ See show subsystems.
Transferring Files ■ 315
Chapter 5: Managing the System
To Next Page
Loading...