Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

show boot
Use to show the current boot settings.■
■ Example
host1#show boot
System Release: release.rel
System Configuration: running-configuration
Note: This system is not configured with backup settings.
■ See show boot.
show hardware
■ Use to display detailed information about the system hardware.
■ Field descriptions
■ slot—Physical slot that contains the module
■ type—Type of module
■ serial number—Serial number of the module
■ assembly number—Part number of the module
■ assembly rev—Hardware revision of the module
■ ram (MB)—Memory capacity of the host processor
■ number of MAC addresses—Total number of Ethernet addresses on an I/O
module
■ base MAC address—Lowest Ethernet address on an I/O module
■ Example
host1#show hardware
serial assembly assembly ram
slot type number number rev. (MB)
---- ---------------- ---------- ---------- -------- ----
0 SRP-10Ge 4305358981 3500005472 A06 2048
1 SRP-10Ge 4305359020 3500005472 A06 2048
2 --- --- --- --- ---
3 --- --- --- --- ---
4 CT3-12 4305337201 3500010901 A07 128
5 OC3/OC12/DS3-ATM 4605300290 3500103958 A06 256
6 GE/FE 4605340294 3500104554 A08 256
number
of
serial assembly assembly MAC
slot type number number rev. addresses
---- ------------- ---------- ---------- -------- ---------
0 --- --- --- --- ---
1 SRP-10Ge I/O 4605250426 3500003302 A02 1
2 --- --- --- --- ---
518 ■ Displaying Boot Information
JUNOSe 11.1.x System Basics Configuration Guide