EasyManuals Logo

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
640 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
â–  Privilege group 15 contains two groups: 14 and 10. The privilege groups 0, 1, 2,
4, 5, 6, 7, 8, 9, 10, and 14 are reachable from privilege group 15.
â–  A user at privilege 15 does not have access to commands in privilege groups 11,
12, or 13.
Example 3 host1(config)#privilege-group membership clear 13
host1(config)#privilege-group membership 13 add 10
In Example 3:
â–  Commands are executed in the following sequence: 15 contains 14, 14 contains
13, 13 contains 12, and so forth,
â–  Privilege group 13 contains one privilege group: privilege group 10.
â–  The privilege groups 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, and 10 are reachable from privilege
group 13.
Example 4 host1(config)#privilege-group membership 12 remove 11
host1(config)#privilege-group membership 12 add 5
host1(config)#privilege-group membership 11 add 5
In Example 4:
â–  Commands are executed in the following sequence: 15 contains 14, 14 contains
13, 13 contains 12, and so forth.
â–  Privilege group 12 contains one privilege group: the privilege group 5.
â–  Privilege group 11 contains one privilege group: the privilege group 5.
â–  Privilege groups 0, 1, 2, 3, 4, 5 are reachable from privilege groups 12 and 11.
Example 5 host1(config)#privilege-group membership clear 9 8 7
host1(config)#privilege-group membership 7 add 1
host1(config)#privilege-group membership 8 add 14
In Example 5:
â–  Privilege group 9 contains no privilege groups.
â–  Privilege group 8 contains group 14.
â–  Privilege group 7 contains group 1.
Example 6 host1(config)#privilege-group alias 13 LI
host1(config)#privilege-group alias 10 dailyAdmin
host1(config)#privilege-group alias 7 weekendAdmin
host1(config)#privilege-group alias 6 dailyTroll
host1(config)#privilege-group alias 5 basicUser
host1(config)#privilege-group alias 0 minUser
host1(config)#privilege-group alias 15 superUser
In Example 6, a number or name can specify the seven privilege groups 0, 5, 6, 7,
10, 13, and 15.
54 â–  CLI Command Privileges
JUNOSe 11.1.x System Basics Configuration Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X and is the answer not in the manual?

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General IconGeneral
BrandJuniper
ModelSYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
CategorySoftware
LanguageEnglish

Related product manuals