Keysight U8903B - Page 400

7 Test Sequence Application
400 Keysight U8903B User’s Guide
Graph
An example of the graph result menu page is displayed as shown in Figure 7-62.
Figure 7-62 Multitone Analyzer > Settings > Result (Spectrum) menu page
Edit Limits
Press the Edit Limits softkey to configure the limits settings.
–Track 1st
If Track 1st trace is enabled, the channel 1 limits settings will be copied to the other channels and the limits settings for
the other channels cannot be edited. Any changes made to the channel 1 limits settings will be reproduced in the other
channels limits settings. Disable the Track 1st trace to set the individual channels limits.
– Lower Limit
Enable or disable the lower limit.
– Upper Limit
Enable or disable the upper limit.
– Lower Limit
Set the lower limit value.
– Upper Limit
Set the upper limit value.
Graph Properties
Press the Graph Properties softkey to set the graph properties.
– Title
Edit the bar chart title.
–X-axis
–Auto Scale
Enable or disable the X-axis autoscale.
–Unit
Select the X-axis unit type.
–Left
Set the X-axis left edge value. This setting is only available when Auto Scale is disabled.
–Right
Set the X-axis right edge value. This setting is only available when Auto Scale is disabled.
Table 7-59 TSA > Project > Test > Measurement > Settings > Result (bar chart) menu description (continued)
Menu Description