Keysight U8903B - Page 433

Appendixes A
Keysight U8903B User’s Guide 433
Waveform Config
(Dual)
Amplitude Set the signal amplitude value.
Frequency Set the signal frequency value.
Frequency 2
Set the second sine wave signal frequency value.
This setting is only applicable for the dual
waveform.
DC Offset Set the signal DC offset value.
Ratio
Set the ratio of the amplitude of the second sine
wave over the first sine wave.
Summation
–RSS
– Linear
.
Summation refers to the method to sum up two
levels.
Waveform Config
(SMPTE 1:1/4:1/10:1)
Amplitude Set the signal amplitude value.
Lower Freq Set the lower frequency value.
Upper Freq Set the higher frequency value.
DC Offset Set the signal DC offset value.
Summation
–RSS
– Linear
Summation refers to the method to sum up two
levels.
Waveform Config
(IEC 60118)
Amplitude Set the signal amplitude value.
Upper Freq Set the higher frequency value.
Diff Freq Set the difference frequency of the waveform.
DC Offset Set the signal DC offset value.
Summation
–RSS
– Linear
Summation refers to the method to sum up two
levels.
Waveform Config
(IEC 60268)
Amplitude Set the signal amplitude value.
Center Freq Set the center frequency of the waveform.
Diff Freq Set the difference frequency of the waveform.
DC Offset Set the signal DC offset value.
Summation
–RSS
– Linear
Summation refers to the method to sum up two
levels.
Waveform Config
(Gaus. Noise)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Waveform Config
(Rect. Noise)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Waveform Config
(Triangular Noise)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Waveform Config
(Pink Noise)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Table A-5 Digital generator menu tree description (continued)
Level 1 Level 2 Level 3 Level 4 Description