Appendixes A
Keysight U8903B User’s Guide 445
Waveform Config
(Constant)
Voltage Set the signal voltage value.
Waveform Config
(Abitrary)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Load File
Load a waveform from a file.
Refer to “Appendix 13: Recall Menu Tree” on
page 494 for the recall menu tree.
Info Display the loaded waveform information.
Waveform Config
(Multitone)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Start Freq
Set the lowest frequency in the multitone waveform
which is usually the frequency for the first tone.
Stop Freq
Set the highest frequency in the multitone waveform
which is usually the frequency for the last tone.
Freq Spacing
– Linear
–Log
– Custom
Select frequency spacing between the tones.
Custom is selected when the custom multitone
waveform is set.
Tones Count Set the number of signal frequency components.
Length
–1024
–2048
–4096
–8192
– 16384
– 32768
– 65536
Select the waveform length that determines the number
of samples used to create one iteration of the multitone
waveform.
Table A-6 Bluetooth generator menu tree description (continued)
Level 1 Level 2 Level 3 Level 4 Description
To Next Page
Loading...
