2-6 Service Manual
4062
44.01 RFID Error Bad tag error: a tag has failed
to program, or the “Retry
Count” has been exceeded.
Note: This error is not a data
parsing error, but indicates bad
RFID media. It is posted only if
the “Stop on Error” menu
setting is set to “ON”.
1. Retest using new RFID
media.
2. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to
“Installing / Removing
the RFID UHF option” on
page 4-149.
3. Replace the RFID UHF
option.
44.11 RFID Error Generic parse error 1. These error codes most
likely indicate a problem
with the customer’s
datastream, and not the
RFID Option itself. Ensure
there is nothing wrong with
the customer’s datastream.
2. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to
“Installing / Removing
the RFID UHF option” on
page 4-149
3. Replace the RFID UHF
option.
44.12 RFID Error Subcommand appears
truncated
44.13 RFID Error Subcommand appears longer
than expected
44.14 RFID Error Subcommand field value was
invalid
44.15 RFID Error Invalid subcommand format
(invalid magic byte)
44.16 RFID Error Subcommand format valid but
not supported
44.17 RFID Error Illegal chars in subcommand
for specified format
44.18 RFID Error Invalid op code
44.19 RFID Error Valid but unsupported op code
44.20 RFID Error Invalid protocol
44.21 RFID Error Valid but unsupported protocol
44.22 RFID Error Unsupported option supplied
for operation
44.23 RFID Error Invalid ID length
44.24 RFID Error Invalid ID bit pattern
44.25 RFID Error Too many tags on page (too
many means more than one)
Error
code or
message
Error contents Description/Action Possible repair actions
To Next Page
Loading...
Need help?
General
