183
4. Open the configuration menu of the alarm panel and then the menu “Sensors”
“Add”. Press “Start”.
5. Press the Learn button of the detector once. The menu should list the
PIR/microwave motion detector after a short while. Press to complete the
connection process.
Range test:
1. Open the alarm panel menu “Sensors” “Range” and press “Start”.
2. Press the Learn button of the dual way motion detector.
3. The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
4.
Please note:
If the signal strength at the place of installation is below 4, we advice to use a wireless
repeater, since it is normal that the signal strength may fluctuate for 2-3 points, thus,
a signal loss is possible.
Motion detection:
Only if the PIR and the microwave sensor detect a motion, an alarm is triggered.
If the range controller set to maximum, the detection range is about 15 meters, if
the motion detector is installed at a height of 1.9 to 2.0 meters (vertical to the wall).
If the range controller set to minimum, the detection range is about 3 to 5 meters,
if the motion detector is installed at a height of 1.9 to 2.0 meters (vertical to the
wall).
Directly underneath the dual way motion detector is a blind spot. We advice to use
two motion detectors in order to secure this spot as well.
Test mode:
By pressing the learn button for a few seconds, you can start the test mode of the
PIR/microwave motion detector. The standby mode is disabled while the test mode runs.
The respective LED will light up with every motion detected.
Microwave test mode:
To adjust the optimal sensitivity/range of the microwave sensor, you can start the test
mode exclusively for the microwave detection. For that purpose, set Jumper 3 (JP3) to
ON. While the microwave test mode is enabled, the microwave LED lights up for 0.5
seconds upon every detected motion. Any further detection extends the duration by 0.5
seconds.
Installation:
You can install the PIR/ microwave motion detector on flat surfaces as well as in corners:
Mounting to flat surface:
To mount the detector to a flat surface, use the mount with the swivel ball head.
Arrest the mount with the screw on top.
Mounting with corner mount:
To mount the detector in a corner, use the provided corner mount.
To Next Page
Loading...