184
Note:
The LEDs (on the front) and the single mounting hook (on the back) must point
upwards for the installation.
First, install the respective mount to the intended place of installation.
Then, fix the PIR/microwave motion detector on the respective mount. The mounting
hooks need to lock in place on the back of the motion detector.
The dual-way motion detector is not pet immune.
The horizontal angle of the PIR / microwave motion detector is 110°.
For optimal motion detection, we recommend installing the PIR/microwave motion
detector at a height of 1.9 to 2.0 meters (6.23 to 6.56 feet) with the back vertical to
the wall.
Do not install the motion detector within the detection range of other detectors (e.g.
motion detectors with light).
Do not expose the motion detector to direct sunlight.
Do not install the motion detector close to heaters or air conditioning devices.
Unless in test mode, the motion detector is able to detect a motion every three
minutes (irrespective of the alarm panel’s status).
To Next Page
Loading...