Lupus Electronics XT 1 Plus - Page 209

209
Please note:
 To use the dual key functions, you need to press the buttons for at least three
seconds.
 To use the dual key functions, you may only press the two corresponding buttons
at once.
Description
Input
Additional functions
Changing the installer PIN
 * + 6
 Enter the current installer PIN – default
0000
 „Status button“  - a long signal is
emited
 Enter the new 4 digit installer PIN
 Pound button # - the new installer key
is saved.
Adding the keypad to the alarm panel /
range test
* + 7
Enable switching to arm / home mode
without entering a PIN code
* + 8
Disable switching to arm / home mode
without entering a PIN code
* + 9
End installer mode
2 x die „Unscharf Taste“ .
Reset / factory default:
If you have forgotten your installation PIN code, you can restore the factory default of the
keypad in the following way:
1. Open the keypad. Be aware that the tampering protection will be triggered!
2. Remove the batteries.
3. Press and hold the button “3” while you are inserting the batteries again.
4. Release the button “3”.
5. After the reset, the installation PIN code will again be 0000.
Please note:
 In the menu “Alarm system”  “Settings”  “Area Settings”  “Arming with
failure” you can allow that the alarm panel will always switch the mode
irrespective of errors.
 If an error is displayed by a flashing error LED, it can be ignored by entering
the PIN code and the mode command again within ten seconds. You can check
(and deactivate / ignore) the current errors of the alarm panel in the menu
“System”  Status”.
 The keypad only transmits its status and battery when it is used. Hence, if you
do not use the keypad for a long time, it is possible that you do not receive a
low battery warning.
 You can use the keypad for both areas depending on the PIN you enter.
 If you realise that you have entered wrong PIN code, you can use the * button
to cancel.