238
You can configure the alarm panel so that the alarm mode is always changed
irrespective of system errors: “Alarm system” “Settings” “Area settings”
“Arming with failure” change “Confirm” to “Force”.
If a system error is indicated (status LED flashes blue), you can usually ignore it
by repeating the entry for arming or home mode within ten seconds. You can view
and ignore the current system errors via “System” “Status”.
The keypad transmits its status “only” upon input. Therefore, it can report that the
batteries are low, but not that they are empty.
If you entered a wrong number or mistyped, you can cancel your input by pressing
on the * button.
The outdoor keypad V2 uses a rolling code encryption.
ATTENTION:
Please change the default user PIN code (1234) via “Home” “PIN codes” as well as
the installer PIN code (0000) to protect your system against manipulation!
To Next Page
Loading...