243
o Activate the option all areas.
o LED 2 will light up and a brief confirmation signal sounds.
o Press the learn button again. LED1&3 light up.
o Change another option of the siren (e.g. change area 1 to area 2).
o LED 2 will light up and a brief confirmation signal sounds.
o Test your settings (e.g. by checking the siren sounds the exit delay for
both areas).
Doorbell
Specify, whether the siren is to give
an acoustic signal with the “Doorbell
function”.
Please note:
In the menu “Siren settings”
“Sound settings” “Area settings”
“Doorbell” ”All sirens off” you can
also disable the doorbell sound for all
sirens.
Alarm volume
Define the siren’s volume in case of
alarms (loud, medium, quiet, mute).
Volume upon arming
Define the volume of the confirmation
sound when arming.
Volume upon disarming
Define the volume of the confirmation
sound when disarming.
Alarm in home mode
Specify, whether the siren is to trigger
an alarm in case of a burglary while
the alarm panel is in home mode.
Alarm in arm mode
Specify, whether the siren is to trigger an alarm in case of a burglary while the alarm
panel is in arm mode.
Activate siren strobe
Specify whether the LEDs of the siren are to flash after the acoustic alarm has ended
until the system is disarmed again.
Confirmation strobe
Specify, whether the siren is to flash for confirmation, when the alarm mode of the
alarm panel changes (Arm/ Home / Disarm).
Please note:
o If you disable the “confirmation signal” in the siren settings above, the
confirmation strobe is also disables irrespective of this setting.
o The confirmation strobe is connected to the option “confirmation signal on/off”
(see above) for sirens manufactured before 2019. If the confirmation signal is
turned off, the confirmation strobe cannot be activated.
Sirens manufactured since 2019 allow an individual setup of the confirmation
strobe and the acoustic confirmation signal.
To Next Page
Loading...