244
Exit strobe
Specify, whether the LEDs of the siren are to flash for confirmation during the delay
when leaving.
Entry strobe
Specify, whether the LEDs of the siren are to flash for confirmation during the delay
when entering.
Please note:
o If you disable the “input” in the siren settings above, the entry and exit strobe
is also disables irrespective of these settings.
o The exit/entry strobe is connected to the option “Input on/off” (see above) for
sirens manufactured before 2019. If the input signal is turned off, the
confirmation strobe cannot be activated.
Sirens manufactured since 2019 allow an individual setup of the confirmation
strobe and the acoustic input signal.
Trigger strobe
Specify whether the siren is to give a visual signal via the three LEDs in case of an
alarm. If activated, the external siren flashes continuously, until the acoustic alarm
has ended.
Attention! If you open the siren without disabling the tampering contact, the acoustic
alarm of the siren will sound – even if the siren is not connected to the alarm panel! In
this case, you should wear ear protection and disconnect the siren as quick as
possible from its power supply.
Warning sounds and signals of the outdoor siren:
The 3 LEDs light up once one after another
The 3 LEDs light up three times
The 3 LEDs light up three times one after another
The 3 LEDs light up five times simultaneously
The 3 LEDs light up five times one after another
Constant beeps until time
has elapsed
The 3 LEDs constantly flash simultaneously
Entrance/exit audio signal
Constant beeps until
time has elapsed
To Next Page
Loading...