26
mode or Range test mode
Off = Area 2 is disarmed, the system memory does not contain any alarm
Please note:
The LEDs of the XT2 (not Plus) area 1 LED flashes green and area 2 LED red during
learn or range test mode.
4. Speaker
Important:
The alarm panel has two areas. When adding a new sensor, the sensor receives an
individual number (zone) for the area in which the sensor is added. By default, it is a
consecutive numbering. The zone number can also be changed later on.
Both areas can be controlled separately, thus, a single XT alarm panel can secure a semi-
detached house.
Each area features five modes: arm, home 1,2, or 3, and disarm.
How the alarm panel reacts in the different modes depends upon the settings of the
individual sensors (see chapter “Edit sensor”). Hence, you can secure the shell of you
home while the motion detectors in the interior of your home will not trigger an alarm while
you are at home.
To Next Page
Loading...