52
of this setting.
24 HR
If this function is active, the set alarm is triggered irrespective of the alarm mode
of the alarm panel, when the sensor is activated.
Disarm / Arm / Home 1 / Home 2 / Home 3 response
Set how the alarm panel reacts if a sensor is triggered in the different alarm modes
o No response
The alarm panel does not react at all, when the sensor is triggered.
o Entry delay 1 / 2
The alarm panel starts the entry delay 1 or 2 if the sensor is triggered. If the
alarm panel is armed or in home mode and a sensor with the property “Entry
delay 1 / 2” is triggered, you can disarm the system within the pre-set time
(see “Alarm system” “Settings” “Area settings” “Entering delay time
1 / 2 ”).
o Mind the exit delay
If this function is active, the sensor will not react during the exit delay
time of the selected mode (Arm, Home 1-3). This function is required
if you want to leave your home without triggering the alarm of a
sensor during the exit delay!
Additionally, if this function is activated, the alarm panel will not
display an error if you change the mode while this sensor is open.
If you have activated “must be closed before arming”, you will still
receive an error if the sensor is open.
o Doorbell
The alarm panel sounds a door bell when the sensor is triggered.
Additionally, the outdoor siren V2 can also sound this doorbell sound (see
siren settings).
o Log entry
There is no notification, but only a log file entry in the alarm panel that the
sensor was activated.
o Log entry (save images)
There is no notification, but only a log file entry in the alarm panel that the
sensor was activated and a snapshot of a PIR network camera is taken.
The snapshot is saved in “Smarthome” “Capture” “Image events”. Be
aware, that this will result in a higher power consumption of your PIR
network camera.
o Burglar alarm Follow
A zone with this property does not trigger the alarm if an entry delay (of
another sensor) was started before. An immediate alarm is triggered if the
entry delay was not activated before.
Example:
Use this sensor property e.g. for a motion detector in the entrance area,
which is directed at the entrance door (equipped with a door contact with
the setting entry delay). Usually, no alarm is triggered, as the premises are
entered through the entrance door. If a burglar accesses the premises
otherwise, the alarm is triggered immediately when he passes this motion
detector.
o Burglar alarm Instant
The sensor triggers the alarm immediately.
o Silent alarm
If a sensor with this setting is triggered, the sirens do not sound an alarm,
To Next Page
Loading...