96
alarm panel! In this case, you should wear ear protection and disconnect the siren
as quick as possible from its power supply.
Confirmation signal on/off (with Arm / Disarm)
With this function active, the siren will sound one signal tone when arming and two
signal tones when disarming the alarm panel.
Please note:
If the tampering contact of the siren is open when arming or disarming the alarm
panel, five short acoustic signals sound even though the confirmation tone is
disabled. This can happen before the alarm panel displays an open tampering
contact, giving you the possibility to react before a tampering alarm is triggered.
Input on/off
With this function active, the external siren(s) sound confirmation signals for the
duration of the defined delay until the system is armed.
Advanced settings
Click on to change the settings of your siren. After you have selected the settings to
your preference, they are saved and the siren sounds a brief sound.
This menu is only available for the outdoor siren and small indoor siren V2 (sold since
Autumn 2018). Depending on the type of siren, this menu may look different (e.g. the
small indoor siren does not have the options to set LEDs, since this siren is not
equipped with LEDs.
Doorbell
Specify, whether the siren is to give
an acoustic signal with the “Doorbell
function”.
Please note:
In the menu “Siren settings”
“Sound settings” “Area settings”
“Doorbell” ”All sirens off” you can
also disable the doorbell sound for all
sirens.
Alarm volume
Define the siren’s volume in case of
alarms (loud, medium, quiet, mute).
Volume upon arming
Define the volume of the confirmation
sound when arming.
Volume upon disarming
Define the volume of the confirmation
sound when disarming.
Alarm in home mode
Specify, whether the siren is to trigger
an alarm in case of a burglary while
the alarm panel is in home mode.
Alarm in arm mode
Specify, whether the siren is to trigger an alarm in case of a burglary while the alarm
panel is in arm mode.
To Next Page
Loading...