215575 124 Revision B
$
Figure 4.40: Header Settings Page
2. Touch HEADER CALIBRATE (A) at the right side of the
HEADER SETTINGS CONFIG page.
Figure 4.41: Header Calibration Warning
3. The hazard warning for HEADER CALIBRATION appears.
Ensure that all conditions are met.
4. Touch the green check mark at the bottom of the page to
start the calibration procedure and follow the on-screen
commands.
Figure 4.42: Calibration in Progress
A progress bar is provided and the calibration can be
stopped by touching the red X. The header moves
automatically and erratically during this process.
AUTO HEADER HEIGHT CONTROL
To Next Page
Loading...
