MacDon PW8 - Conversion Chart

215575 318 Revision B

%
$
Figure 5.221: Transport Light
3. Remove two screws (A) using a Phillips-head screwdriver.
4. Pry off lens (B).
5. Push the bulb in and turn it counterclockwise. Remove the
bulb.
6. Place the new bulb in the socket, push it in, and turn it
clockwise until the bulb can’t be turned any further.
7. Replace lens (B) and secure it with two screws (A).
5.12.3 Replacing Lens
To ensure the life of the light bulb, replace the lens if it is cracked or broken.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop the engine and remove the key from
the ignition before leaving the operator’s seat for any reason.
1. Lower the header fully.
2. Shut down the engine, and remove the key from the ignition.

%
$
Figure 5.222: Transport Light
3. Remove two screws (A) using a Phillips-head screwdriver.
4. Pry off lens (B).
5. Install new lens (B) and secure it with two screws (A).
5.12.4 Replacing Lamp Housing
Transport lights are an important safety feature. Replace the lamp housing if it is cracked or broken.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop the engine and remove the key from
the ignition before leaving the operator’s seat for any reason.
1. Lower the header fully.
2. Shut down the engine, and remove the key from the ignition.
MAINTENANCE AND SERVICING