215575 36 Revision B
3.8 Break-In Period
Follow this procedure during the first 10 hours of operating your pick-up header.
DANGER
To avoid injury or death from unexpected start-up of the machine, always stop the engine and remove the key from
the ignition before leaving the operator’s seat for any reason.
1. After attaching the header to the combine for the first time, operate the machine at low speed for five minutes while
carefully watching and listening FROM THE OPERATOR’S SEAT for any sounds of binding or interfering parts.
2. Refer to 5.2.1 Maintenance Schedule/Record, page 216 and perform the instructions listed under the heading
10 Hours.
NOTE:
Until you become familiar with the sound and feel of your new header, be extra alert and attentive.
OPERATION
To Next Page
Loading...
