MacDon PW8 - Setting Preset Cutting Height (John Deere S and T Series)

215575 195 Revision B

$
Figure 4.186: John Deere Combine Command Center
1. Press button (A). The current manual raise/lower speed
setting will appear on the monitor.

$
Figure 4.187: John Deere Combine Display
2. Press – or + icon (A) to adjust the manual raise/lower
speed.
NOTE:
The numbers depicted on the displays in these illustrations
are for reference purposes only; they are not intended to
represent specific settings for your equipment.
4.13.6 Setting Preset Cutting Height (John Deere S and T Series)
You will need to configure both preset header heights on your John Deere S or T series combine to use the auto header
height control (AHHC) system with your header.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator’s manual for updated information.
AUTO HEADER HEIGHT CONTROL