MacDon PW8 - Adjusting Manual Header Raise;Lower Rate (John Deere S and T Series)

215575 194 Revision B

$
Figure 4.184: John Deere Combine Command Center
1. Press button (A) twice. The current sensitivity setting will
appear on the combine display.

$
Figure 4.185: John Deere Combine Display
2. Press – or + icon (A) to adjust the sensitivity.
NOTE:
The numbers depicted on the displays in these illustrations
are for reference purposes only; they are not intended to
represent specific settings for your equipment.
4.13.5 Adjusting Manual Header Raise/Lower Rate (John Deere S and T Series)
The speed at which the header rises or falls on a John Deere S or T series combine can be adjusted from the combine cab.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator’s manual for updated information.
AUTO HEADER HEIGHT CONTROL