MacDon PW8 - Removing Hydraulic Motor Hoses

215575 238 Revision B
Removing Hydraulic Motor Hoses
Be sure to cap or otherwise protect the hose ends to prevent contamination from dust or dirt while the hoses are
removed.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop the engine and remove the key from
the ignition before leaving the operator’s seat for any reason.
1. Lower the header to the ground, and lower the hold-down completely.
2. Shut down the combine and remove the key from the ignition.

$
Figure 5.37: Left Endshield
3. Open left endshield (A). Refer to 3.3.1 Opening Left
Endshield, page 25 for instructions.

$
%
%
$
Figure 5.38: Left Side of Header
4. Remove hose clips (A) and cinch straps (B).
NOTE:
Parts have been removed from the illustration so that the
hydraulic hoses can be seen.
MAINTENANCE AND SERVICING