MacDon PW8 - Adjusting Header Height - Challenger 6 Series; Adjusting Header Raise;Lower Rate - Challenger 6 Series

215575 149 Revision B
4.8.4 Adjusting Header Height – Challenger
®®
6 Series
Once the auto header height control (AHHC) system is activated, press and release the HEADER LOWER button on the
control handle. The AHHC will automatically lower the header to the preset height.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. For instructions,
refer to the combine operator’s manual for updated information.

$
Figure 4.97: Height Adjustment Knob on Combine
Control Console
The selected AHHC height is adjusted using HEIGHT
ADJUSTMENT knob (A) on the control console. Turning the knob
clockwise increases the selected height. Turning the knob
counterclockwise decreases the selected height.
4.8.5 Adjusting Header Raise/Lower Rate – Challenger
®®
6 Series
The speed at which the header rises or falls can be adjusted on a Challenger
®
6 Series combine.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. For instructions,
refer to the combine operator’s manual for updated information.

Figure 4.98: Challenger
®®
Combine Display
1. Press the header icon on the FIELD page. The HEADER page
appears.
AUTO HEADER HEIGHT CONTROL