MacDon PW8 - Aligning Front Draper Deck Rollers

215575 287 Revision B

%
$
Figure 5.155: Left Front Deck – Right Side Opposite
10. Install bolt (A) (if previously removed), ensuring that
shield (B) is in place.

&
%
$
Figure 5.156: Left Front Deck – Right Side Opposite
11. Secure bearing (A) with lock nuts (B).
12. Install lock collar (C) onto the bearing and rotate the lock
collar clockwise using a hammer and punch until tight.
NOTE:
Rotate the lock collar counterclockwise when installing the
right front deck idler bearing.
13. Tighten the set screw on the lock collar.
14. Remove the wooden blocks supporting the roller.
15. Align the draper deck rollers. Refer to Aligning Front Draper
Deck Rollers, page 287 for instructions.
Aligning Front Draper Deck Rollers
Align the draper rollers on the front deck to ensure that the draper belt tracks properly. Perform this procedure after
replacing a roller bearing.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop the engine and remove the key from
the ignition before leaving the operator’s seat for any reason.
1. Lower the header to the ground.
2. Shut down the engine, and remove the key from the ignition.
3. Open the left endshield. For instructions, refer to 3.3.1 Opening Left Endshield, page 25.
MAINTENANCE AND SERVICING