MacDon PW8 - Page 257

215575 241 Revision B

$
%
&
'
(
)
Figure 5.45: Multicoupler on Rear of Header
2. Route hose (A) and hose (B) through grommet (C) in the
bottom beam cover. Match the colored cable ties and
attach hose (A) and hose (B) to the multicoupler. If the
colored cable ties are missing, attach the hoses as follows:
a. Attach longer hose (A) to the forward port on the
forward drive motor and to connector (E) on the
multicoupler.
b. Attach shorter hose (B) to the aft port on the rear drive
motor and to connector (F) on the multicoupler.
c. Secure the hoses with cinch strap (D).

&
$
'
%
Figure 5.46: Left Side of Header
3. Connect hose (A) to front hydraulic motor (B). Connect
shorter hose (C) to front hydraulic motor (B) and rear
hydraulic motor (D).
NOTE:
The end of hose (C) (which has an angled fitting) attaches
to rear motor (B).

$
&
%
'
'
Figure 5.47: Left Side of Header
4. Connect hose (A) to front hydraulic motor (B) and rear
hydraulic motor (C).
5. Secure the hoses with cinch straps (D).
MAINTENANCE AND SERVICING