MacDon PW8 - Page 280

215575 264 Revision B
$
$
(
(
)
'
&
%

Figure 5.101: Rear Draper Belt End
5. Rotate draper belt (A) until connecting belt edge
protector (E) is situated on top of the draper deck, and
remove and retain the following hardware:
• M6 flange nut (F)
• belt edge protector (E)
• retainer (D) (from between the draper overlap)
• guide (C)
• pronged elevator bolt (B)
NOTE:
Remove the elevator bolts only if you are replacing the
draper.
NOTE:
Parts have been removed from the illustration to show
clearly the removal order of the hardware and the draper
belt interior.

$
%
&
'
Figure 5.102: Rear Draper Belt
6. Remove remaining M6 flange nuts (A), connector bars (B),
and pronged elevator bolts (C) from draper belt (D).
NOTE:
Remove the elevator bolts only if you are replacing the
draper.
MAINTENANCE AND SERVICING