215575 13 Revision B
Figure 1.26: MD #191099
MD #191099
Auger entanglement hazard
DANGER
To prevent injury:
• Stop the engine and remove the key before opening the
shield.
• Do NOT operate the header without shields in place.
General hazard pertaining to machine operation and servicing
DANGER
To prevent injury or death from the improper or unsafe
operation of this machine:
• Read the operator’s manual and follow these safety
instructions. If you do not have a manual, obtain one from
your Dealer.
• Do NOT allow untrained persons to operate the machine.
• Review these safety instructions with all Operators every
year.
• Ensure that all safety signs are installed and are legible.
• Make certain that bystanders are clear of the header before
starting the engine and while operating the header.
• Keep riders off of the machine.
• Keep all shields in place during operation and stay clear of
moving parts.
• Disengage the header drive, put the transmission into
Neutral, and wait for all movement to stop before leaving
the operator’s position.
• Stop the engine and remove the key from the ignition
before servicing, adjusting, lubricating, cleaning, or
unplugging the header.
• Engage the safety locks to prevent the unit from falling
while it is being serviced in the raised position.
• Display a slow-moving vehicle emblem and activate the
warning lights when operating the header on roadways
(unless these actions are prohibited by law).
SAFETY
To Next Page
Loading...
