215575 281 Revision B
Figure 5.140: Right Rear Deck Idler Roller
7. Loosen locking collar (A) and three nuts (B) securing the
bearing flange to the frame on the right side of the header.
8. Loosen locking bolt (C).
Figure 5.141: Left Rear Deck Alignment Indicator
9. Turn adjuster nut (A) and draw the rear draper deck roller
assembly into the header until the leading edge of bearing
support plate (B) lines up with the middle of single
cutout (C) on each side of the header.
Figure 5.142: Left Rear Deck Shown – Right Side
Opposite
10. Measure from the center of the rear drive roller to the
center of the front driven roller (distance [A]). Ensure that
distance (A) is 490 mm (19 5/16 in.) on each side of the
header before tightening the hardware on the bearing
flanges.
MAINTENANCE AND SERVICING
To Next Page
Loading...
