MacDon PW8 - Page 355

rod angle ........................................................... 96
hydraulic cylinders
replacing hold-down hydraulic cylinders..........297, 300
bleeding cylinders and lines ............................. 303
slave cylinders
installing ................................................... 302
removing .................................................. 300
hydraulic hoses and lines ....................................... 304
replacing cylinder hoses
installing master cylinder hose ......................... 308
removing master cylinder hose ........................ 305
hydraulic motors
draper drives.................................................... 233
front hydraulic motors
installing ...................................................... 235
removing...................................................... 233
hydraulic motor hoses
installing ...................................................... 240
removing...................................................... 238
rear hydraulic motors
installing ...................................................... 237
removing...................................................... 236
hydraulics
hydraulic safety .................................................... 6
I
IDEAL
™
combines
attaching ........................................................... 38
J
John Deere combines .............................................. 58
attaching to 60/70, S, T series................................ 58
detaching from 60/70, S, T series ........................... 62
L
lift cylinder safety props
header .............................................................. 32
lights ............................................................. 78, 317
transport lights
adjusting lights .............................................. 317
replacing lamp housing ................................... 318
replacing lens................................................ 318
replacing light bulbs ....................................... 317
lubricating headers ............................................... 220
greasing points ................................................. 221
greasing procedure............................................ 220
installing sealed bearing ..................................... 224
M
maintenance and servicing..................................... 215
end of season service......................................... 219
lubricating the header........................................ 220
maintenance record .......................................... 216
maintenance requirements ................................. 216
maintenance schedule ....................................... 216
preparing header for servicing............................. 215
preseason/annual service ................................... 218
safety..................................................................5
Massey Fendt IDEAL combines, See Fendt IDEAL combines
Massey Ferguson combines, See AGCO combines
Massey Ferguson IDEAL combines, See AGCO IDEAL
combines
master cylinders
bleeding cylinders and lines ................................ 303
installing.......................................................... 299
installing hose .................................................. 308
master cylinder
removing master cylinder................................ 300
removing ......................................................... 297
removing hose.................................................. 305
replacing master cylinder.................................... 297
motors
removing rear hydraulic ..................................... 236
N
New Holland combines............................................ 64
attaching to ....................................................... 64
detaching from ................................................... 68
O
operating heights ................................................... 90
header height ..................................................... 90
pick-up height .................................................... 91
adjusting pick-up height ....................................91
operating speeds.................................................... 79
auger speed ....................................................... 80
draper speed...................................................... 80
operator responsibilities .......................................... 23
options
augers
auger dent repair kit ...................................... 323
combine completion package kits ........................ 324
hold-down performance kits ............................... 321
owner responsibilities ............................................. 23
P
pan seal assembly
adjusting rubber seal ......................................... 101
INDEX