1128 Matrix PRASAR UCS System Manual
For instructions on configuring a DSS key on an Extended IP Phone, see “DSS Key Settings” in “Configuring Matrix
SPARSH VP330”, “DSS Key Settings” in “Configuring Matrix SPARSH VP248”, “DSS Key Settings” in “Configuring
Matrix SPARSH VP310” and “DSS Key Settings” in “Configuring Matrix SPARSH VP510”.
Configuring System Activity Log using Jeeves
• Login as System Engineer.
• Under Configuration, click System Log.
• Click System Activity Log.
• To generate System Activity Log - Online
• Select the Enable check box.
•In Destination IP Address, enter the IP Address of the remote Syslog Server. Both IPv4 and IPv6
addresses are supported.
•In Port, enter the port of the remote Syslog Server. Valid port range is: 514; 1025 to 65535.
By default, 514 is assigned.
• To generate System Activity Log - Report, that is, offline, whenever desired
• Select the Enable check box.
•In Destination IP Address, enter the IP Address of the remote Syslog Server. Both IPv4 and IPv6
addresses are supported.
•In Port, enter the port of the remote Syslog Server. Valid port range is: 514; 1025 to 65535.
• Click Submit.
How to use
You can start and stop System Activity Log - Online and Report from the System Administrator mode using Jeeves
To Next Page
Loading...