Matrix PRASAR UCS System Manual 353
For each Time Zone, you may select the desired DISA option from the following:
• Disabled: Select this option if you want to disable DISA.
• PIN Auth.-Multiple calls: Select this option if you want to enable DISA with PIN Authentication and
allow multiple calls during the DISA login session.
• CLI Auth.-Multiple calls: Select this option if you want to enable DISA login with CLI Authentication
and allow multiple calls to be made during the DISA login session.
Caller numbers that do not match with the CLI Table will be routed as per the logic of the Trunk Feature
Template.
• CLI Auth.-One call: Select this option if you want to enable DISA session with CLI Authentication, and
allow only a single call to be made during the DISA login session. This form of DISA is used when
PRASAR UCS is installed in a Gateway application.
By default, DISA is disabled for all Time Zones.
• Click Submit.
SMDR Storage
The Station Message Detail Recording (SMDR) feature of PRASAR enables you to record the details of Incoming
(IC) and Outgoing (OG) calls made from/on the trunks. To obtain SMDR as a report, you must enable SMDR
Storage, and set filters. See “Station Message Detail Recording (SMDR)” to know more.
• Click SMDR Storage to expand.
• Store Incoming Call: By default this check box is selected. The system will store the details of incoming
calls from the trunk. Please refer the topic “Station Message Detail Recording-Storage” for more details.
Clear the check box to disable.
• Store Outgoing Call: By default this check box is selected. The system will store the details of outgoing
calls on the trunk. Please refer the topic “Station Message Detail Recording-Storage” to know more. Clear
the check box to disable.
• Click Submit.
To Next Page
Loading...