354 Matrix PRASAR UCS System Manual
Call Cost Calculation
PRASAR UCS can calculate the cost in amount for the external calls made by the extension users. You need to
configure the following parameters:
• Click Call Cost Calculation to expand.
• Call Cost Calculation Pulse Rate Option: This parameter is to be configured only if you want to apply
the “Call Cost Calculation (CCC)” feature on the trunks on which the template is applied.
You have four options for Pulse Rate Types. Select from Pulse Rate Type for Pulse Rate Option 1 to 4
which you want to apply on the trunks.
• Call Cost Calculation Time Schedule: This parameter is to be configured only if you want to apply the
“Call Cost Calculation (CCC)” feature on the trunks on which the template is applied.
The Pulse Rates offered by service providers may vary according to the time of the day. In such cases, you
must first define the Time Zone (time of the day) for which a particular Pulse Rate should be applied and
the Time Schedule for each Time Zone.
You can configure up to four different Time Zones - Time Zone 1, Time Zone 2, Time Zone 3 and Time
Zone 4 with different Pulse rates in the CCC. For details refer “Configuring Pulse Rate Types”.
Now, configure the Call Cost Calculation Time Schedule, by specifying the Start Time and the End time (in
24hours: minutes format) for each Time Zone.
The default Time Schedule (starts and end time) for each Time Zone Index are as follows:
If your service provider offers the same Pulse Rate for the entire day,
Time Zone
Index
Start Time End Time
Time Zone 1 00:00 23:59
Time Zone 2 00:00 23:59
Time Zone 3 00:00 23:59
Time Zone 4 00:00 23:59
To Next Page
Loading...