Matrix PRASAR UCS - Page 450

Matrix PRASAR UCS System Manual 441
After the digits have been assigned, the system will proceed further as per the options selected by you. Given
below is the brief description of each option:
• Re-record: The system will clear the recorded message and let the caller record a new message again.
This is applicable only if you have enabled the Message Verification check box.
• Confirm: The system will save the recorded message as per the option set by you in No Digit Dialed
Action. This is applicable only if you have enabled the Message Verification check box or selected the Ask
Caller as the Message Type and/or Message Sensitivity option.
• Urgent: The system will save the recorded message as Urgent message. This is applicable only if you
have selected the Ask Caller as the Message Type option.
• Private (Confidential): The system will save the recorded message as Private message. This is
applicable only if you have selected the Ask Caller as the Message Sensitivity option.
• Listen Recorded Message: The system will play the recorded message to the caller and then play the
message leave options again. This is applicable only if you have enabled the Message Verification check
box.
• Append to Recorded Message: The system will let the caller record a new message again and add it to
the existing recorded message. This is applicable only if you have enabled the Message Verification check
box.
• System will check — Maximum Message Length, New Message Delivery Option in Mailbox Full
Condition etc — before allowing the caller to append the recorded message.
• The Message, that is, the recorded message along with the appended message cannot exceed the
Maximum Message Length. Hence, the system will allow recording of the appending message only till
it reaches the Maximum Message Length.
•In No Digit Dialed Action, if no digit is dialed by the caller, the system will take action as per the Message
Type and Message Sensitivity configured.
This is applicable only if you have enabled the Message Verification check box or selected the Ask Caller
as the Message Type and/or Message Sensitivity option.
Based on the configuration, you may select the desired action — Normal+Normal, Urgent+Normal,
Normal+Private or Urgent+Private.