440 Matrix PRASAR UCS System Manual
• Select Set as Private, if you want the system to store the messages received in the mailbox as Private.
The message left by the external callers or replied by the internal callers will be considered as
confidential and forwarding the message will be restricted.
• Select Ask Caller, if you want the system to ask the caller to select the message sensitivity before
storing the recorded message in the mailbox. If the call gets disconnected before the caller selects the
message sensitivity, the message will be set as normal by default. You must configure the “Message
Leave Settings”.
• The Message Security parameter is reserved for future use. Keep this check box disabled.
• Select the Message Leave Confirmation Prompt check box if you want the system to play the prompt to
the caller after leaving the message. The Message Type and Message Sensitivity that you configured will
be played.
If you disable the check box, the system will not play the Message Leave Confirmation prompt to the caller
after leaving the message.
Message Leave Settings
Message Leave Options will be played based on the configuration of the parameters — Message Verification,
Message Type and Message Sensitivity.
You can assign the Digits (0-9, *, # or None) to each of the options — Re-record, Confirm, Urgent,
Private(Confidential), Listen Recorded Message and Append to Recorded Message.
Make sure you do not assign the same digit to multiple options.
The digit you configure will be played as the digit to be dialed by the caller to select the respective option. The
options will be played in the sequence — 1-9, 0, *, #. The option for which the digit selected is None will not be
played.
To Next Page
Loading...