Matrix PRASAR UCS System Manual 587
However, if Auto Redial/Auto Redial Priority is to be allowed on only selected extensions, follow these steps:
1. Define a CoS group with Auto Redial/Auto Redial Priority enabled.
2. Prepare a Station Basic Feature Template with this CoS group applicable in all the “Time Zones”.
3. Assign this new Template to the extensions to which Auto Redial/Auto Redial Priority is to be allowed.
Refer the topics “Class of Service (COS)” and “Station Basic Feature Template” for detailed instructions.
To change Auto Redial Counts and Timers:
• Login as System Engineer.
• Under Configuration, click System Timers and Counts.
• Below Auto Redial, change the Count and Timer of the type of Auto Redial - Normal or Priority - as per
your requirement.
• You may change any of the related timers - Auto Redial Ring Back Tone (RBT) Wait Timer, Auto Redial
Ring Timer - as per your preferences on this page.
• Click Submit.
• If the PRASAR UCS is installed in Australia, please ensure that:
i. The Timer for Auto Redial Normal as well as Priority must be set to more than 5 seconds.
ii. The Auto Redial Priority Count should be set to less than 15.
• Click Submit to save your setting
To Next Page
Loading...