Matrix PRASAR UCS - Page 77

68 Matrix PRASAR UCS System Manual
Refer to the diagram below for connectivity.
4. Connect the Handset.
• Plug the long straightened end of the Spring Cord into the handset jack at the bottom of the phone,
marked with the handset symbol .
• Plug the other (short straight) end of the Spring Cord into the jack at the bottom of the handset.
5. Connect the Headset (not supplied by Matrix).
• To use a Headset (not supplied with the phone), plug any standard stereo headset with 3.5mm single
connector into the headset audio jack at the bottom of the phone, marked with the symbol .
OR
You may also plug in a headset with an RJ9 connector into the headset port at the bottom of the
phone, marked with the symbol .
6. Connect to the IP Network.
• Plug one end of the Ethernet Cable into the LAN Port at the bottom of the phone, marked with the
symbol and the other end to the IP Network — A Router or LAN Switch.
7. Connect a PC to the Phone.
• Plug one end of the Ethernet Cable into the PC Port at the bottom of the phone, marked with the
symbol and the other end into the LAN Port of your PC/LAN Switch.
Handset
AUX