Matrix PRASAR UCS System Manual 69
8. Connect DSS532 with the Phone.
• To connect DSS532 with the phone, plug one end of the RJ11 cable into the AUX Port of the phone and
the other end into the IN Port of the DSS532. For installation, see “Installing DSS532 with SPARSH
VP510”.
9. Connect the Power Supply.
• Plug the connector of the Power Adapter in to the power jack at the back of the phone, marked with the
symbol . Use only the adapter provided with the phone to prevent any damages that may
arise from the use of other adapters.
If you want to use Power over Ethernet (PoE), ensure that your LAN supports PoE. Supply power
through an 802.3af connection on the LAN Port of the phone. In this case you need not connect the
Power Adapter.
10. Plug the Power Adapter into a power outlet.
If both the power options, that is, PoE as well as Power Adapter are available to the phone, then the phone
will derive power from the PoE enabled LAN Switch.
11. Switch ON power supply.
When you power the phone, the boot process will be initiated in the following sequence.
• All keys with LED, including the Speaker key, and the Ringer LED, will glow.
• The LCD display will light up and the booting message appears.
• Then the ‘Loading...’ message appears on the phone display.
• The phone will start loading the Extended IP Phone Firmware.
It will display current firmware being
loaded.
• After loading the firmware, the phone will prompt you to change Network settings.
• Wait for a few seconds.
If you want to change the Network Settings or Server Settings, press Yes key. Detailed instructions for
changing the Network Settings of the phone are provided at the end of this topic. See “Network Settings” at
the end of this topic.
• The phone makes DHCP Discovery and fetches its IP Address and Server Address from the DHCP
Server.
On getting the IP Address and Server Address, the phone initiates Auto Configuration to download the
configuration files from PRASAR UCS.
• As the phone downloads the configuration files, the file names will appear one by one.
• On successful download of all configuration files, the phone attempts to register with PRASAR UCS.
To Next Page
Loading...