Matrix PRASAR UCS System Manual 789
The access codes for the department groups and extensions in this table are default access codes.
Now, with this information ready, you may configure the department groups using Jeeves.
Enabling Call Forward for Department Call in Class of Service
To be able to set Call Forward for the Department Group, member extensions must have this feature enabled in
their COS.
By default, Station Basic Feature Template Number 01 is assigned to all the extensions of PRASAR UCS, the
default COS group 01 in the Station Basic Feature Template has ‘Department Group Call Forward’ enabled. So, all
extensions of PRASAR UCS can set Call Forward Department Group.
If you wish to allow this feature to member extensions only, retain this feature ‘Department Group Call Forward’ in
the COS group of member extensions, and disable Call Forward feature in the COS of all the extensions. For this,
you may create separate Station Basic Feature Templates for member extensions and other extensions.
Refer the topic “Class of Service (COS)” and “Station Basic Feature Template” for instructions.
Configuring Department Groups using Jeeves
• Login as System Engineer.
• Under Configuration, click Department Groups.
Creating Department Groups
• To create a Department group, assign an Access Code for the department group against the Index
Number.
By default, the Access Codes assigned to Department groups for Index Numbers 1 to 16 are 3901 to 3916
and for Index Numbers 17 to 32 is blank.
If you decide not to use the default access codes, ensure that the access code you assign to each
department group is unique and does not match with any extension access code or any feature access
code of the Dial Phase. Refer the topic “Access Codes” to know more.
To Next Page
Loading...