INSTALLATION - BRAVO DRIVES - 2C-590-823225--1 1096
IMPORTANT: Turn both front engine mount ad-
justment nuts an equal amount in direction re-
quired to align engine.
d. Adjust front engine mounts until they rest on
boat stringers.
e. Relieve hoist tension entirely and fasten both
front mounts to boat stringer using appropri-
ate hardware (lag bolts or thru-bolts, etc.).
f. Recheck alignment with alignment tool. Tool
must enter coupler splines freely. If not,
readjust front mounts.
g. When alignment is correct, tighten locknut or
nut with lockwasher on each mount securely.
h. Bend tab washer down against flat on adjust-
ing nut.
72922
b
c
d
a
e
a - Locknut
b - Adjustment Nut
c - Turn Adjustment Nut In This Direction (Counterclockwise)
To Raise Front Of Engine
d - Slotted Hole To Front Of Engine
e - Tab Washer
i. Remove alignment tool if not already re-
moved.
8. Tighten all exhaust system hose clamps securely
as follows (use two hose clamps on each connec-
tion):
a. On Engines with Thru-Prop Exhaust:
72537
b
a
a
a - Hose Clamps - Tighten Securely
b - Exhaust Tube - Long Tube, Port Side - Short Tube, Star-
board Side
72538
CORRECT
INCORRECT
To Next Page
Loading...
