INSTALLATION - BRAVO DRIVES - 2C-990-823225--1 1096
WEBER 4 BARREL CARBURETOR
71159
a - Throttle Shaft Lever [Contacts (b) at W.O.T. Position]
b - Carburetor Body Casting
Wide-Open-Throttle Position
b
a
70392
a - Throttle Lever [Contacts (b) in Idle Position]
b - Idle Speed Adjustment Screw
Idle Position
b
a
ELECTRONIC FUEL INJECTION (EFI)
1. Place remote control handle in neutral idle posi-
tion.
2. Remove flame arrestor.
3. Install cable end guide on throttle lever, then push
cable barrel end lightly toward throttle lever end.
(This will place a slight preload on shift cable to
avoid slack in cable when moving remote control
lever). Adjust barrel on throttle cable to align with
hole in anchor plate.
b
c
e
f
g
h
a
74109
d
Throttle Body Injection
a - Cable End Guide
b - Throttle Lever Stud
c - Locknut and Flat Washer - Tighten Until Nut Bottoms
Out, Then Back Off One Half Turn
d - Throttle Lever
e - Throttle Bracket
f - Cable Barrel
g - Flat Washer and Locknut
h - Throttle Cable Anchor Stud
To Next Page
Loading...
