2C-10 - INSTALLATION - BRAVO DRIVES 90-823225--1 1096
a
b
74183
c
d
74174
Multi-Port Injection
a - Lock Nut and Flat Washer Tighten Until Bottoms Out, Then
Back Off One Half Turn.
b - Cable End Guide
c - Throttle Cable Anchor Stud
d - Cable Barrel
IMPORTANT: Do not attach any accessory
ground (–) wires to transom plate ground point.
Accessory ground wires should only be attached
to ground stud on engine.
4. Secure throttle cable with hardware as shown
and tighten securely.
NOTE: If Boat is equipped with Quicksilver Zero Ef-
fort Controls, the throttle cable mounting stud must
be most forward position on throttle lever.
73855
a
a - Position for Zero Effort Controls
5. Place remote control throttle level in the wide
open throttle (W.O.T.) position. Check to ensure
that throttle plates are completely open.
6. Return remote control throttle lever to idle posi-
tion and check to ensure that throttle plates are
completely closed.
7. Connect any grounding wires or accessories that
may have been disconnected.
8. Models with MerCathode: Connect wires to
MerCathode controller assembly as shown.
Apply a thin coat of Quicksilver Liquid Neoprene
to all connections.
22232
b
c
d
a
a - ORANGE Wire - From Electrode On Transom Assembly
b - RED/PURPLE Wire - Connect (Other End) to Positive
(+) Battery Terminal
c - BLACK Wire - From Engine Harness
d - BROWN Wire - From Electrode on Transom Assembly
To Next Page
Loading...
