INSTALLATION - BRAVO DRIVES - 2C-1190-823225--1 1096
IMPORTANT: Adjust shift cables as outlined in
appropriate Stern Drive Service Manual.
9. Refer to appropriate Stern Drive Service Manual
and install and adjust drive unit and remote con-
trol shift cables, using hardware retained.
IMPORTANT: After fluid hose installation in the
following, bleed power steering system as out-
lined in SECTION 1B - “Maintenance” of this man-
ual, or refer to the appropriate Stern Drive Ser-
vice Manual.
!
CAUTION
Route hoses exactly as shown below. This will
help avoid stress on the hose fittings and will
help avoid kinks in the hose.
IMPORTANT: Make hydraulic connections as
quickly as possible to prevent fluid leakage.
IMPORTANT: Be careful not to cross-thread or
over- tighten fittings.
10. Connect both hydraulic hose fittings.
a. Earlier Style Control Valves: Torque the
large fitting to 23 lb. ft. (31 N·m). Torque the
small fitting to 100 lb. in. (11 N·m).
22023
a
b
a - Small Fitting
b - Large Fitting
b. Later Style Control Valve: Torque both fit-
tings to 23 lb. ft. (31 N·m). Route hoses as
shown for each model.
73786
a
a - Hose Fittings
11. Connect battery cables to battery by FIRST con-
necting positive (+) battery cable (usually RED)
to positive (+) battery terminal. Tighten clamp se-
curely. Then, connect negative (–) battery cable
(usually BLACK) to negative (–) battery terminal.
Tighten clamp securely.
NOTE: Spray terminals with a battery connection
sealant to help retard corrosion.
To Next Page
Loading...
