2D-14 – MCM MODELS - BRAVO MODELS WITH DRIVE SHAFT EXTENSIONS 90-823225--1 1096
IMPORTANT: After fluid hose installation in the
following, bleed power steering system as out-
lined in appropriate Stern Drive Service Manual.
9. Connect both hydraulic hose fittings.
!
CAUTION
Route hoses exactly as shown below. This will
help avoid stress on the hose fittings and will
help avoid kinks in the hose.
IMPORTANT: Make hydraulic connections as
quickly as possible to prevent fluid leakage.
IMPORTANT: Be careful not to cross-thread or
overtighten fittings.
a. Earlier Style Control Valves: Torque the
large fitting to 23 lb. ft. (31 N·m). Torque the
small fitting to 100 lb. in. (11 N·m).
22023
a
b
a - Small Fitting
b - Large Fitting
b. Later Style Control Valve: Torque both fit-
tings to 23 lb. ft. (31 N·m). Route hoses as
shown for each model.
73786
a
a - Hose Fittings
NOTE: Spray terminals with a battery connection
sealant to help retard corrosion.
10. Using double hose clamps on all connections, in-
stall exhaust hoses and exhaust tubes as shown
in “a” or “b” following. Tighten all hose clamps se-
curely.
a. On Engines with Thru-Prop Exhaust:
72027
a - Exhaust Pipe
b - Exhaust Hose
c - Hose Clamps
d - Exhaust Tube
Starboard Side Engine End Shown (Port
Similar)
b
c
d
a
c
72584
a - Exhaust Separator Assembly
b - Exhaust Hose
c - Hose Clamps
d - Exhaust Tube
Starboard Side Transom End Shown
(Port Similar)
b
c
d
a
c
To Next Page
Loading...
