2E-10 - MIE MODELS - VELVET DRIVE TRANSMISSIONS 90-823225--1 1096
f. Place remote control shift lever in forward
gear position and check position of transmis-
sion shift lever. Shift lever must be positioned
as shown.
!
CAUTION
Remote control and shift cable must position
transmission shift lever exactly as shown, or
transmission failure may occur. Do not remove
poppet ball or spring.
b
c
d
a
72601
FN R
e
a - Transmission Shift Lever
b - Shift Lever Must Be Over This Letter when Propelling
Boat FORWARD
c - Shift Lever Must Be Over This Letter when Propelling
Boat in REVERSE
d - Poppet Ball Must Be Centered in Detent Hole for
Each F-N-R Position (Forward Gear Shown)
e - Install Shift Lever Stud in This Hole, if Necessary, to
Center Poppet Ball in Forward or Reverse Detent Holes
g. Place remote control shift lever in reverse
gear position and again check transmission
shift lever position. Lever must be positioned
as shown by (c).
h. If transmission shift lever will position proper-
ly in one gear, but not in the other, recheck
shift cable adjustment. If transmission shift le-
ver will not position properly in both gears,
move transmission shift lever stud (a), from
top hole in shift lever, to bottom hole (e), and
recheck for proper positioning. If proper posi-
tioning is still not obtained, remote control
does not provide sufficient shift cable travel
and must be replaced.
i. Install nut and washer to cable end guide
stud. Tighten until snug, then back off one full
turn.
j. Install nut and washer to cable barrel stud.
Tighten until they bottom out. Tighten secure-
ly, but DO NOT OVER-TIGHTEN.
SINGLE STATION INSTALLATIONS
72528
Single Station Installation In-line and
V-Drive - Rear Approach
b
d
e
a
f
g
c
a - Cable End Guide
b - Cable Barrel
c - Cable Barrel Stud
d - Elastic Stop Nut and Washer
e - Spacer
f - Cable End Guide Stud
g - Elastic Stop Nut and Washer
a - Cable End Guide
b - Cable Barrel
c - Cable Barrel Stud
d - Elastic Stop Nut and Washer
e - Spacer
f - Cable End Guide Stud
g - Elastic Stop Nut and Washer
72605
Single Station Installation In-Line and
V-Drive - Front Approach
b
d
e
a
f
g
c
To Next Page
Loading...
