Mercury 305 CID - Page 166

MIE MODELS - VELVET DRIVE TRANSMISSIONS - 2E-1190-823325--1 1096
DUAL STATION INSTALLATIONS
72604
Dual Station Installation In-Line and
V-Drive - Rear Approach
b
d
e
a
f
g
c
a - Cable End Guide
b - Cable Barrel
c - Cable Barrel Stud
d - Elastic Stop Nut and Washer
e - Spacer
f - Cable End Guide Stud
g - Elastic Stop Nut and Washer
72606
Dual Station Installation In-Line and
V-Drive - Front Approach
a - Cable End Guide
b - Cable Barrel
c - Cable Barrel Stud
d - Elastic Stop Nut and Washer
e - Spacer
f - Cable End Guide Stud
g - Elastic Stop Nut and Washer
b
d
e
a
f
g
c
7. Follow instructions “a” or “b”:
a. On Models Equipped with Other Than
Quicksilver Throttle Cables: Attach and
adjust throttle cables referring to cable man-
ufacturer’s instructions.
b. On Models Equipped with Quicksilver
Throttle Cables: Connect and adjust throttle
cable(s) as outlined following:
(1) Place remote control throttle lever(s) in
idle position.
(2) Install cable end guide on carburetor
throttle lever stud as shown. Push cable
barrel lightly toward throttle lever. (This
will place a slight preload on cable to
avoid slack in cable when moving remote
control levers.) Then adjust cable barrel
to align with anchor stud and slide barrel
onto stud.
(3) Secure throttle cable with hardware as
shown. Tighten cable end guide locknut
until it bottoms out and then back off one
full turn. Tighten barrel locknut until se-
cure, but DO NOT OVER-TIGHTEN as
cable(s) must be able to pivot.
72014
a – Cable End Guide
b - Attaching Hardware (DO NOT Over-Tighten)
c - Cable Barrel
d - Anchor Studs
b
d
a
c
d
b
b